Nov 062016
 

After spending mucho brain power to determine the best route for EGT and CHT wires I finally started cutting them to length and fitting the terminals.  This needed to be spot on because I’m routing all 8 cables from the pilot side firewall pass through and reaching the probes on the #2 cylinder, the farthest away, was going to be tough  I don’t want to splice in any additional wire if they don’t reach.  Thankfully they juuust make it.

img_4732

Right side above and left side below

img_4733

Above you can see the brown CHT and EGT wires exit the pass through then turn upwards and right. They run along below the oil pressure line through adel clamps to the right side.

 Posted by at 3:06 PM