Installed the E-Buss fuse holder on left side of avionics shelf. I was going to put this on the lower wall of the baggage compartment along with the Battery Buss and the Main Buss but I don’t want any screw heads, nuts or nutplates in the baggage compartment. I don’t want to snag items putting them in and taking them out.
Here is the Main Buss on the right side. I still have to locate the battery buss.
Fit the GMU 22 connector and secured the wiring in place.
Ran the elevator servo wires and attached the db connector.
The temperature probe will not fit through any of the bulkhead holes so I disassembled it from the harness and put it into the wing. I’ll create a connector for it later. It’s just three wires in slots 1, 2 and 3 plus a green ground that had to be cut.
Now it fits in the left wing.