Sep 162018

Vertical Stabilizer tip installed.  You can just make out the patch I installed to cover the cutout where the previous builder was going to install cat whiskers.

Both HS tips installed.  Each of these were epoxy primed.  I’m not bothering with finishing the fiberglass past one or two coats of epoxy primer.  Let the painter deal with it.  I need to get this plane flying this year.

Elevator tips installed and epoxy primed.

Rudder bottom epoxy primed and installed.  Bucking bar is weighing down the 1×1 piece of fiberglass covering the cutout as it’s epoxied into place.

Second coat of epoxy primer on the inside of the canopy frame.  This will be sanded and painted and then I’ll install the canopy.

 Posted by at 1:30 PM