Bonded the front bulkhead in place. Clamped inside just to keep it 1/4 away from the panel.
Bent a bunch of tabs to force the canopy down as far as possible while the front bulkhead is bonded. The tape roll helps pull in the sides just a tad.
Same on the other side.
Riveted in the Skybolt tabs along bottom of the firewall. Drilled out the holes to #30, dimpled and countersunk the tabs. Riveted in place with 4-4 and 4-5 where the tabs overlap.
Started working on the lower cowl again. Everything is fitting superbly. It really helps doing this before. The second time around is just a breeze in comparison. I also trimmed the upper portion of the canopy to 7/8″ where the bubble will sit. You can see the discard on the floor.