Epoxied the left side rail in place.
The only portion of the canopy that doesn’t fit perfectly is the left rear. Here I used some leverage to move the side inwards while the side rail was clamped in position.
While the epoxy was setting up I went to work on the cowl. There is a lot of on-off-on-off work when fitting the lower cowl. Get a couple rolls of clear tape, you will need it. Everything looks pretty darn good so tomorrow I will cut the top of the lower cowl to match the top, which I cut today. At this point there are no paint gaps except for the aft portion of the top cowl.